The Agfa D-Workflow interface allows the APM or Lab 50 software to convert orders generated from an APM into a format that D-Workflow (version 2.64 or higher) can accept and print.

Prerequisites

  1. The APM and/or Lab 50 software needs to be able to see the D-Workflow machine across the local area network and vice versa.
  2. D-Workflow must be on version 2.64 or higher and use 28k ATTY files on the APM/Lab 50 and D-Workflow machines.
  3. If Lab 50 is not present in the local installation, then at least one or more fulfillments must be enabled to print to a local printer connected to the APM. This is seen in the screenshot below, taken from the main options of an enabled fulfillment in the Setup Wizard.

 

 

Print Settings

 

 

Setting up the D-Workflow Using Setup Wizard

The Setup Wizard is used to configure the APM to print to the D-Workflow Interface.

This process includes the following steps:

  1. Adding the printer interface and editing the general settings.
  2. Product setup from within the interface.
  3. Assigning printable products to the interface.