Editing the JobMaker Interface Settings

Sending orders straight from the kiosk (Print Server):

1. Press the bottom, left corner of the intro screen.
2. Enter the pass code (default is 1234).
3. Select the Setup Wizard.

Using Lab 50 installed on a separate computer:

1. Click on the Settings tab in Lab 50.
2. Select the Fulfillment option on the left side of the screen to expand it.
3. Select Print Server
4. Press the Setup Wizard button and the Setup Wizard will launch.

Once you have the Setup Wizard open:

1. Click on Printer Configuration.
2. Click on Add Printer.
3. In the menu at the right, select Fuji JobMaker.
4. In the Printer Name field, enter "PIC", or any name you wish to use.

Fuji JobMaker Options:

• Order File Location Dest: Enter the location of the Orders folder on the Fuji machine using the UNC naming convention.

**Note: If the Fuji machine is called "PIC390", then the setting should be changed from C:\APM-XXXX\JobMaker\Orders to \\PIC390\Orders\.

• Image File Location: Enter the location of the Images folder on the Fuji machine using the UNC naming convention.

**Note: If the Fuji machine is called "PIC390", then the setting should be changed from C:\APM-XXXX\JobMaker\Images to \\PIC390\Images\.

• Purge Days: Enter the number of days that all order files and images should reside in the folders as defined above. If this is set to 0, the files will remain indefinitely. Otherwise, files from these locations that are older than the given number of days will be erased upon boot up. The recommended default is three days.

• Glossy Surface Code: The code for the glossy surface as specific in the JobMaker paperinfo.ini file. Default setting is G.

• Matte Surface Code: The code for the matte surface as specific in the JobMaker paperinfo.ini file. Default setting is M.

• Automatic Image Correction: Performs automatic image correction for all photos. These settings are defined in the JobMaker software. Default setting is True.