You will need the following tools to successfully complete the replacement of your Media Card Reader
- A flat clean surface work surface to place both the APM and components removed during install
- The Keys that are shipped with the APM (The larger of the two sets with the number 301 inscribed on it)
- Phillips Screw Driver (small to medium size)
- The Replacement Card Reader
Safety Note:
before touching any internal components especially circuit boards, make sure the APM is turned off and unplugged from the wall, surge strip etc. Also ensure you are completely grounded to prevent electro-static discharge that can damage the internal circuit boards found in the Kiosk.
Step 1-- Unlocking Front Bezel |
|
|
---|---|---|
|
|
|
|
|
|
Step 2 – Remove/Replace the Card Reader and/or CD Drive: |
||
|
|
|
|
|
|
|
|
|
Step 3 – Remove/Replace the Card Reader and/or CD Drive: |
|
|
|
|
|
|
|
|
|
|
|
Step 4 – Reinstallation of the Drive: |
|
|
Reverse the above steps to install the new or replacement media card reader. orientate the three cables that run into media card reader cables to match the position of their receptacles before installing the media reader, this makes it easier to install the connectors. You can also feel for the receptacles using your hand, or spy their location from the space found towards the rear of the kiosk that space is created when the cable management/ back bezel (Power, Ethernet etc) is removed.
|
|