When an APM is set up to print using the local print engine, there must be a local printer connected to the machine. In most cases, the generic Hot Folder Interface is already setup as a placeholder until further configuration occurs.
**Note: Repeat Steps 1-4, as needed, to setup each printer interface. When you add a new printer, it is displayed in the list of printers in the Primary Navigation Pane.
Once your printer interfaces have been added, you will need to configure the settings in each individual interface.
The APM software is compatible with a wide variety of printer models. To obtain detailed instructions on configuring the settings for a specific model printer, refer to the Table of Contents for the appropriate Appendix for each of the interfaces applicable to your setup.
3. Repeat for any additional printers.
|