You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 17
Next »
You will need the following tools to successfully complete the replacement of your Media Card Reader
- A flat clean surface work surface to place both the APM and components removed during install
- The Keys that are shipped with the APM (The larger of the two sets with the number 301 inscribed on it)
- The Replacement Hard Drive
- Phillips Screw Driver (small to medium size)
Step 1-- Unlocking Front Bezel |
|
- Place the APM-3700 on a flat surface with the front of the kiosk facing you
|
|
- Insert the provided key (The larger of the 2 sets provided) into the lock located on the top left of the Kiosk’s front bezel. Set the lock to the “on” position.
|
|
Step 2 — Remove/Replace the Card Reader and/or CD Drive: |
|
- Carefully pry the front bezel cover from the chassis, working from left to right. No tools are required for this step as the design allows for its removal with your bare hands. There are two markings (arrows) on the upper left and right corners of the bezel that show were the clips are located. Little pressure should be applied to those locations to free the bezel off the chassis as shown to the right
|
|
- Completely remove the front bezel and place it somewhere safe. Now that the bezel is removed that will leave the Optical Drive & Receipt printer tray exposed._ _
|
|
- Pull the tray out of the bay using the two silver tabs located at near the bottom of the Kiosk. A small amount of force needs to be applied to pull the tray our which is connected to a daughter board to the rear of the tray.
|
|
Step 3 --Remove/Replace the Receipt Printer: |
|
- With the Tray out, remove the two ribbon cables that go from the thermal receipt printer (Mechanical Print Head) to the thermal receipt printer’s controller board.
- The two ribbon cables have to be removed from the controller board.
|
|
Once the two ribbon connects are released from the controller board orientate the tray so that the Receipt printer (front) is facing you. Open the receipt printer door. This will give you access to the two small screws that secure the receipt printer to the receipt printer chassis. See pictures to the right: |
|
Step 4 – Remove Rollers from the back of front panel (Optional and only if necessary) |
|
- With the receipt printer door released use screw to remove the two screws that secure the roller assembly as shown to the right
|
|
Step 5-- Remove /Replace the Controller Board (Optional and only if necessary) |
|
- There are three screws that secure the controller board to the receipt printer chassis.
See images to the right for the location of the three screws.
|
|
Step 6-- Remove /Replace the Power Converter Board (Optional and only if necessary) |
|
- Disconnect the Molex connector that runs from the converter board to the daughter board.
- Remove the connector from the daughter board then remove the connector attached directly to the converter board for the sake of ease.
- The location of the four screws that secure the converter board in placed are marked with circles to the right and are on the green circuit board.
|
|