You will need the following tools to successfully complete the replacement of your Media Card Reader
- A flat clean surface work surface to place both the APM and components removed during install
- The Keys that are shipped with the APM (The larger of the two sets with the number 301 inscribed on it)
- The Replacement Hard Drive
- Phillips Screw Driver (small to medium size)
Safety Note:
before touching any internal components especially circuit boards, make sure the APM is turned off and unplugged from the wall, surge strip etc. Also ensure you are completely grounded to prevent electro-static discharge that can damage the internal circuit boards found in the Kiosk.
Step 1-- Unlocking Front Bezel |
|
---|---|
|
|
|
|
Step 2 — Remove/Replace the Card Reader and/or CD Drive: |
|
|
|
|
|
|
|
Step 3 --Remove/Replace the Receipt Printer: |
|
---|---|
|
Warning
Please use caution to not damage the ribbon cables on removal and reinstall. The ribbon cables are secured into place by plastic tabs that have to be released before the ribbon cables can be safely pulled out
|
|Once the two ribbon connects are released from the controller board orientate the tray so that the Receipt printer (front) is facing you. Open the receipt printer door. This will give you access to the two small screws that secure the receipt printer to the receipt printer chassis. See pictures to the right: |
|
Step 4 – Remove Rollers from the back of front panel (Optional and only if necessary) |
|
---|---|
|
|
Step 5-- Remove /Replace the Controller Board (Optional and only if necessary) |
|
---|---|
|
|
Step 6-- Remove /Replace the Power Converter Board (Optional and only if necessary) |
|
---|---|
|
|