Page History

•    Place the APM-3700 on a flat surface with the front of the kiosk facing you

• Insert the provided key (The larger of the 2 sets provided) into the lock located on the top left of the Kiosk’s front bezel. Set the lock to the “on” position.

• .Carefully pry the front bezel cover from the chassis, working from left to right. No tools are required for this step as the design allows for its removal with your bare hands. There are two markings (arrows) on the upper left and right corners of the bezel that show were the clips are located. Little pressure should be applied to those locations to free the bezel off the chassis as shown to the right

• Completely remove the front bezel and place it somewhere safe. Now that the bezel is removed that will leave the Optical Drive & Receipt printer tray exposed. 

  Tip
  title Bezel Removal
  If the clips that secure the bezel to the chassis will not come loose. Use a screwdriver at the location of clip 3(see image above), carefully push the clip in until it is released from the chassis.

• Pull the tray out of the bay using the two silver tabs located at near the bottom of the Kiosk. A small amount of force needs to be applied to pull the tray our which is connected to a daughter board to the rear of the tray. The red arrows  in the image to the right

!3700_CDDVD_Receipt.png

thumbnail,border=1!

•  With the bay occupied by the Optical Drive and Receipt printer empty, this leaves clear access to the back of the Media Card Reader from within the empty bay.
• The Media Card Reader is connected to via three cables, a custom USB connector, an ATX Molex Connector and a standard USB (B) Connector.  The three cables must be detached from the back of the card reader before it can be removed. Those cables are attached to other cables via zip ties, pulling the card reader out without first disconnecting the mentioned cables could damage those other components.

•  Once the cables are unplugged, remove the 4 screws found on the sides of the card reader (2 are found on each side of the card reader). Once the 4 screws are removed it will allow the Media Card Reader to freely slide out of its chassis.

•  Push the back of the card reader with your fingers until enough of it protrudes for you to get a firm grip on it, to pull it completely free of the chassis.

Reverse the above steps to install the new or replacement media card reader.