...
You will need the following tools to successfully complete the replacement of your Media Card Reader:
- A flat clean surface work surface to place both the APM and components removed during install
- The Keys that are shipped with the APM (The larger of the two sets with the number 301 inscribed on it)
- Phillips Screw Driver (small to medium size)
- The Replacement Card Reader
Warning | ||
---|---|---|
| ||
before touching any internal components especially circuit boards, make sure the APM is turned off and unplugged from the wall, surge strip etc. Also ensure you are completely grounded to prevent electro-static discharge that can damage the internal circuit boards found in the Kiosk. |
Step 2 – Remove/Replace the Card Reader and/or CD Drive: |
| |
---|---|---|
|
|
|
|
| |
|
| |
|
|
|
|
| |
1-- Unlocking Front Bezel |
| |
|
|
|
|
| |
|
| |
Step 2 – Remove/Replace the Card Reader and/or CD Drive: |
| |
|
|
|
|
a) The Media Card Reader is connected to via three cables, a custom USB connector, an ATX Molex Connector and a standard USB (B) Connector. The three cables must be detached from the back of the card reader before it can be removed. Those cables are attached to other cables via zip ties, pulling the card reader out without first disconnecting the mentioned cables could damage those other components.
b) Once the cables are unplugged, remove the 4 screws found on the sides of the card reader (2 are found on each side of the card reader). Once the 4 screws are removed it will allow the Media Card Reader to freely slide out of its chassis.
c) Push the back of the card reader with your fingers until enough of it protrudes for you to get a firm grip on it, to pull it completely free of the chassis.
| |||||||||||
Step 2 – Remove/Replace the Card Reader and/or CD Drive: |
| ||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
|
| ||||||||||
|
|
...