...
- In Lab 50 or myLab, look up the folio product you want to duplicate (like 5x7 flat card), jot down the Product ID.
- Create a new product (push Create New Product btn in upper left of Lab 50; ensure to set the 'Product Type' to be the same as the existing product) and in the Product ID box (green), copy in that Product ID from step 1.
- If you need it to print to a different channel or have different production settings than the originating product ID does, then assign a different ID for printing (yellow box). Use an ID in the 9000 - 9999 range, which are reserved for custom dealer products that we do not need to assign/reserve/be notified of. Pick an ID within that range and go with it (record what you are using so you don’t duplicate it later). You will need to add the product to your apmconfig_products_custom.xml file and then configure it for printing in the Setup Wizard. (instructions follow)**
- (Otherwise the ID from the green box will be used for printing---which is already a product so that is already in your products xml file, which tells the system where to print the product... this is fine if it prints to the same place the original one does.)
- Once you add your product, it's added to the All Products folder. Now, find the category where this new product should go(this would be in the folder with the small blue check mark icon), right-click and Add Product, then go find you new product. To zero in on it faster, check the Recents folder or the group where you put it when you defined it.
...