Step 1 - Open the Case: | |
---|
1. - Start by taking out the screws from the rear casing. There are four on top and one on each side.
| 2. |
- There is a fifth screw located behind the monitor and underneath the receipt panel, make sure to unscrew that as well.
| 3. |
- Once the casing is unscrewed
take it off- , remove the casing from the hardware.
| 4. |
| 5. |
- Unscrew the side-mounted screws from the front panel.
| 6. |
- Pull to remove the front panel.
| |
Step 2 – Remove/Replace the Card Reader and/or CD Drive: | |
---|
7. - Take the screws out of the card reader bracket.
| 8. |
- Unplug the IDE cable and power supplies connected to the CD/DVD drive.
| 9. |
- Unplug the PCMCIA SCSI cable from the SCSI card.
| 10. |
- Unplug the USB connected to the inside of the card reader. The card reader should slide out of the front of the unit.
| 11. |
- To replace the CD/DVD drive, get a small
screw driver - screwdriver and unscrew it from the bracket.
| 12. |
- Slide the CD/DVD drive forward.
| 13. |
- To replace the card reader
undo - , unscrew the large screws from the bracket.
| 14. |
- The card reader should slide forward.
| |