...
New products will default to use the Hotfolder driver for printing. If you would like to route them differently, you will need to add the products to your apmconfig_products_custom.xml file on Lab 50, then use the Setup Wizard on Lab 50 to configure routing.
In Notepad (or better, Notepad++), open apmconfig_products_custom.xml (located in C:\Program Files\Lucidiom Lab 50\Tools\PrintServer). If this file does not yet exist, open a new file, and from apmconfig_products.xml, copy top two lines of the apmconfig_products.xml and the bottom line into a new xml file and save it as apmconfig_products_custom.xml. It will look like this
(where the red above is the product (or products) you have copied)::
Code Block language xml <?xml version="1.0" ?> <products units="all"> <product name="4x6 Fancy Print" description="4x6 Fancy Print" width="6000in" height="4000in" minwidth="800" minheight="530" position="9003" id="9003" type="1" /> </products>- Replace the ID and position code with the same ID in the 9000-9999 block that you used in the dialog box (the yellow highlighted box in the screenshot). The product ID and position code should use the same number. Don’t repeat a number you have already used.
- Save as apmconfig_products_custom.xml in the same folder location where the apmconfig_products.xml is located, which for a Lab 50 machine is C:\Program Files\Lucidiom Lab 50\Tools\PrintServer
- Configure as needed in Lab 50's Setup Wizard.