Versions Compared

Old Version 19

changes.mady.by.user Russ McIver

Saved on

compared with

New Version 20

changes.mady.by.user Russ McIver

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Step 3 --Remove/Replace the Receipt Printer:

 

  • With the Tray out, remove the two ribbon cables that go from the thermal receipt printer (Mechanical Print Head) to the thermal receipt printer’s controller board.
  • The two ribbon cables have to be removed from the controller board.
    Warning
    titleWarning

    Please use caution to not damage the ribbon cables on removal and reinstall. The ribbon cables are secured into place by plastic tabs that have to be released before the ribbon cables can be safely pulled out

  • Once the two ribbon connects are released from the controller board orientate the tray so that the Receipt printer (front) is facing you.
  • Open the receipt printer door. This will give you access to the two small screws that secure the receipt printer to the receipt printer chassis. See pictures to the right:

Step 4 – Remove Rollers from the back of front panel (Optional and only if necessary)

 

  • With the receipt printer door released use screw to remove the two screws that secure the roller assembly as shown to the right

...

Step 6-- Remove /Replace the Power Converter Board (Optional and only if necessary)

 

  • Disconnect the Molex connector that runs from the converter board to the daughter board.
  • Remove the connector from the daughter board then remove the connector attached directly to the converter board for the sake of ease.
  • The location of the four screws that secure the converter board in placed are marked with circles to the right and are on the green circuit board.