Versions Compared

Old Version 11

changes.mady.by.user Russ McIver

Saved on

compared with

New Version 12

changes.mady.by.user Russ McIver

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Step 1-- Unlocking Front Bezel

 

  •    Place the APM-3700 on a flat surface with the front of the kiosk facing you

  • Insert the provided key (The larger of the 2 sets provided) into the lock located on the top left of the Kiosk’s front bezel. Set the lock to the “on” position.

Step 2 – Remove/Replace the Card Reader and/or CD Drive:

 

  • .Carefully pry the front bezel cover from the chassis, working from left to right. No tools are required for this step as the design allows for its removal with your bare hands. There are two markings (arrows) on the upper left and right corners of the bezel that show were the clips are located. Little pressure should be applied to those locations to free the bezel off the chassis as shown to the right

  • Completely remove the front bezel and place it somewhere safe. Now that the bezel is removed that will leave the Optical Drive & Receipt printer tray exposed. 
    Tip
    titleBezel Removal

    If the clips that secure the bezel to the chassis will not come loose. Use a screwdriver at the location of clip 3(see image above), carefully push the clip in until it is released from the chassis.

  • Pull the tray out of the bay using the two silver tabs located at near the bottom of the Kiosk. A small amount of force needs to be applied to pull the tray our which is connected to a daughter board to the rear of the tray.

Step 3 – Remove/Replace the Card Reader and/or CD Drive:

 

The APM-3701 SATA Hard Drive is located toward the back of the kiosk; once the optical bay and receipt printer is removed, the hard drive chassis and the two screws that secure it into place will be exposed follow these actions

  • Remove both the SATA data cable and SATA power cable.
  • Remove the two screws used to secure the hard drive cage.
  • Slide the hard drive cage/chassis out along with the hard drive. Slide the hard drive chassis to the left to free it from the two metal hooks that help secure it in place.

Place the hard drive on a flat clean surface and remove the four screws that secure the hard drive to the hard drive chassis/cage. After removal of the mentioned screws the hard drive cage/chassis can then be freely removed from the Hard Drive:

Image Added