...
You will need the following tools to successfully complete the replacement of your Media Card Reader:
a) A flat clean surface work surface to place both the APM and components removed during installb)
- The Keys that are shipped with the APM (The larger of the two sets with the number 301 inscribed on it)
...
- Phillips Screw Driver (small to medium size)
...
- The Replacement Card Reader
...
| Warning |
|---|
|
before touching any internal components especially circuit boards, make sure the APM is turned off and unplugged from the wall, surge strip etc. Also ensure you are completely grounded to prevent electro-static discharge that can damage the internal circuit boards found in the Kiosk. |
Step 2 – Remove/Replace the Card Reader and/or CD Drive: | |
|---|
- Carefully pry the front bezel cover from the chassis, working from left to right. No tools are required for this step as the design allows for its removal with your bare hands. There are two markings (arrows) on the upper left and right corners of the bezel that show were the clips are located. Little pressure should be applied to those locations to free the bezel off the chassis
| | |
- Completely remove the front bezel and place it somewhere safe. Now that the bezel is removed that will leave the Optical Drive & Receipt printer tray exposed.
| |
| |
- *tip; if the clips that secure the bezel to the chassis will not come loose. Use a screwdriver at the location of clip 3(see image above), carefully push the clip in until it is released from the chassis.
| | |
- With the bay occupied by the Optical Drive and Receipt printer empty, this leaves clear access to the back of the Media Card Reader from within the empty bay.
| |
...