Step 1 - Open the Case: | |
|---|
1. - Start by taking out the screws from the rear casing. There are four on top and one on each side.
|  2. |
- There is a fifth screw located behind the monitor and underneath the receipt panel, make sure to unscrew that.
|  3. |
- Once the casing is unscrewed take it off.
|  4. |
|  5. |
- Unscrew the side-mounted screws from the front panel.
|  6. |
- Pull to remove the front panel.
|  |
Step 2 – Remove/Replace the Card Reader and/or CD Drive: | |
|---|
7. - Take the screws out of the card reader bracket.
|  8. |
- Unplug the IDE cable and power supplies connected to the CD/DVD drive.
|  9. |
- Unplug the PCMCIA SCSI cable from the SCSI card.
|  10. |
- Unplug the USB connected to the inside of the card reader. The card reader should slide out of the front of the unit.
|  11. |
- To replace the CD/DVD drive, get a small screw driver and unscrew it from the bracket.
|  12. |
- Slide the CD/DVD drive forward.
|  13. |
- To replace the card reader undo the large screws from the bracket.
|  14. |
- The card reader should slide forward.
|  |