Page History

Step 1 - Open the Case:
1. Start by taking out the screws from the rear casing. There are four on top and one on each side.	Image Added
2. There is a fifth screw located behind the monitor and underneath the receipt panel, make sure to unscrew that.	Image Added
3. Once the casing is unscrewed take it off.	Image Added
4. Remove the cover plate.	Image Added
5. Unscrew the side-mounted screws from the front panel.	Image Added
6. Pull to remove the front panel.	Image Added

Step 2 – Remove/Replace the Card Reader and/or CD Drive:
7. Take the screws out of the card reader bracket.	Image Added
8. Unplug the IDE cable and power supplies connected to the CD/DVD drive.	Image Added
9. Unplug the PCMCIA SCSI cable from the SCSI card.	Image Added
10. Unplug the USB connected to the inside of the card reader. The card reader should slide out of the front of the unit.	Image Added
11. To replace the CD/DVD drive, get a small screw driver and unscrew it from the bracket.	Image Added
12. Slide the CD/DVD drive forward.	Image Added
13. To replace the card reader undo the large screws from the bracket.	Image Added
14. The card reader should slide forward.	Image Added

Versions Compared