...
- The APM and/or Lab 50 machine needs to be able to see the Noritsu machine across the local area network and vice versa.
- On the Noritsu machine, the necessary print channels need to be setup prior to the APM/Lab 50 setup. This includes separate channels for glossy/matte finishes.
- The Noritsu machine needs to be on Version E or higher.
- If Lab 50 is not present in the local installation, then at least one or more fulfillments must be enabled to print to a local printer connected to the APM. This is seen in the screenshot below, taken from the main options of an enabled fulfillment in the Setup Wizard.
Advanced Tables - Table Plus | ||||
---|---|---|---|---|
| ||||
|
Setting up the Noritsu DPOF Using the Setup Wizard
The Setup Wizard is used to configure the APM to print to Noritsu DPOF Interface.
This process includes the following steps:
- Adding the printer interface and editing the general settings.
- Product setup from within the interface.
- Assigning printable products to the interface.
- Pulling the order into the Noritsu software.